Applies to : ZWCAD+ 2015


In ZWCAD, there are some hidden options that are very useful, here is track for object snapping.


Here is an example (Draw a pipe (circle) at the specified distance from the wall corner):

Detail steps:

  1. Run CIRCLE, with OSNAP enabled.
  2. Input TRACK or TK
  3. Snap the wall corner (marked by red circle above), enable Ortho mode
  4. Follow the X axis, input 200, Enter
  5. Follow the Y axis, input 200, Enter
  6. Then center point of circle is located, then input 50 for the Radius, the pipe (circle) has been done.
If you do not use TK, it would be much complicated to draw such circle, so it is very convenient to use in your design.