Applies to: ZWCAD 2015
Note: This command can be used only after installing 'ZWCAD_ EXTRA-PLUS_TOOL-KIT_ENU.msi'.
A. Summary
Lets you identify the number of a certain type of block based on certain criteria.
B. Functions and procedures
Command: COUNTBLOCKSNUM
Procedures:
1. Start command, show under dialog.
2.
3. Then enter a block name. You can also input the layer as a filter condition, or press the ">" button in the diagram directly behind the loot to statistical figure block name and the layer. If you want to search statistics on other layers , do not check the layer. In addition, you can also choose whether to "ignore the insertion point of the same piece" or "ignore ratio < = XX blocks".
4. Set the options in the picture frame to after the range of statistics, click on the "statistics" button to find out the range of quantity statistics, command line prompt: "please choose tiles, determine the scope of the statistics end < enter > :", this time continue to choose other ranges, and according to the "statistics" button statistical center piece of the number of these regions